Nasa wind masthead with A032—also discussed the connections with A031/A033

After checking the other post I have done the following connection today. Just in case somebody needs this I would like to share my job here:)

If your NASA wind masthead outputs at 10Hz rate don’t try it. As the other post has discussed, it only works with Quark’s A033, not A032.

By connecting below two wires,

Nasa mastherd TX—-> A032 NMEA in-

Nasa mastthead GND—-> A032 GND

the wind speed and angle data shows on my Raymarine AXIOM7 MFD now.