- This topic has 1 reply, 2 voices, and was last updated 3 years, 7 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hello,
I’ve just started to play with A026+. I’m unsuccessful with connecting Nasa Wind masthead device v 2.0 (three wire: blue, red and black). I’ve read suggestions posted for example here https://www.quark-elec.com/forum/topic/cannot-get-a031-to-work-solvedalso-discussed-nasa-masthead-clipper-issue/#post-14304 and tried to feed-in the wind data with no success
Maybe A026+ has the same issue with signal rate (10Hz vs 1Hz) as A032 or A033 had (don’t remember which).
Marek
Hi, Connect your blue wire to NMEA input – and connect NMEA input+ with the black(which should be GND) of your NASA masthead, then it should work. Keep us updated please.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.